Screens & Infusers

Showing 6 products

Trub Trapper

A boil kettle filtration system designed to capture the break material and pelleted hops

Sized for 10 and 15 gallon kettles

Dimensions - 9" DIA x 2.7" HGT

Passivized stainless steel body

Food grade silicone gaskets capable of temps to 600F

MB_BE550
$49.99

Stainless Steel Hop Filter - 400 Micron

Keep your hops and other additive out of your brew with this 400 micron stainless steel filter! Hops, trub and spices in beer can clog up ball valves and drainage systems, and can lead to an inordinate amount of particulate matter making its way to the primary fermenter, where it can cloud beer and cause issues when bottling or kegging. Make sure it never makes it to the primary with this brew filter! Essentially a 4" x 10" basket that hangs on the edge of your brew kettle, this ingenious device acts as a hop spider to keep hops out of your brew, or in the case of spiced ales, can keep spices and bits of dried fruit peel out as well! A lifesaver if running your wort through plate or counterflow chillers, it can also be used as a recirculation filter. Handcrafted in the U.S.A.! Keep all the gunk from getting out of the brew kettle with this handy stainless steel brew filter!

Features:
  • Basket measures 4 x 10 in. making it perfect for kettles of 10 gallons or less
  • Hangs directly on the side of your existing pot
  • Stainless steel construction
  • 400 Micron mesh screen
  • Made in the U.S.A.

GF_GF803
$42.50

Boil T-Screen

This heavy duty multi-purpose stainless screen (with a copper T fitting in the middle) is designed for converting a standard commercial keg into a mash tun (or boiling pot with a filter tube on the bottom).

13 inches long, with a 1/2 inch copper pipe outlet in the center.

Recommended for Sanke kegs.

73-2015
$12.99

HopBlocker, Blichmann Engineering

Tired of hop and break material ending up in your fermenter, and not staying in your brew pot where it belongs? Then the HopBlocker from Blichmann Engineering is your answer. Traditional screen filters draw from the bottom of your brew pot, where they immediately suck hops and break material into the screen, where they plug up. With Blichmann Engineering's HopBlocker, you can filter out up to 90-95% of this material without plugging! The secret is in their unique two-stage filter design. The first part of your wort that is above the hop sediment is drawn through a coarse filter. Next, the wort that is at the bottom of your pot goes through the fine filter, which can simply be activated by lifting up the hook on the HopBlocker. While the HopBlocker was specifically designed to complement the BoilerMaker brew pots from Blichmann, it can be installed in any manufacturer's pot or keg.

Note: For best results, after your boil has completed, stir vigorously to create a whirlpool in your brew pot, and then allow 15-20 minutes for the hop and break sediment to settle neatly in a pile at the bottom. For use with pellet hops only. Whole/leaf hops will plug the HopBlocker. If using whole hops, place them in a large muslin grain bag.

GF_GF232
$59.99