Blichmann Accessories & Parts

Add this item to your cart if you would like to have a hole punched in your BoilerMaker brew pot (also in your cart) for use with the Low Level Float Switch.

Need to increase your range of motion with the Blichmann Autosparge? A longer float rod can do just that! Three inches longer than the standard 6" float road that comes with the Autosparge, this float road can give you more range of motion for large brews and brew kettles. A minimum pot or mash tun diameter of 15" is required for use of the 9" float rod. Easily installed by simply screwing into the Autosparge body and float ball, this will help you to use the Autosparge to its fullest potential!

Doing big brews or using big equipment with the Blichmann Autosparge? You might consider going with a longer float rod! A full six inches longer than the 6" float rod that comes standard on the Blichmann Autosparge, this longer rod can give you a wider range of motion for bigger brew kettles and mash tuns. This gives your more control and flexibility with your sparging capabilities. A minimum pot or mash tun diameter of 18" is required for use of the 12" float rod. Get the most out of your Autosparge!

Replacement dip tube bulkhead fitting for the Blichmann BoilerMaker.

Do you have a worn or missing O-ring for the BrewMometer on your brew kettle? Over time, O-rings will wear down, fray and eventually disintegrate. A missing or faulty O-ring can mean the difference between a successful brew day and wort leaking all over while you curse your bad luck. Replace that O-ring, or have backup on hand just in case! The BrewMometer O-ring from Blichmann Engineering is the perfect replacement for your Brewmometer!

No one likes a leaky brew kettle! The BoilerMaker line of brew kettles from Blichmann Engineering contain a number of o-rings to seal in all the high-tech components. Over time, these can wear, and excessively rough cleaning techniques can cause them to break or (more commonly) get lost. Never put off brewing due to a lost or broken o-ring again! This kit comes with all the replacement o-rings you need for a BoilerMaker brew kettle, including external seals for the three-piece ball valve, sight glass and Brewmometer. Very handy to have on hand in case of a brew day emergency!

Bottom dump fitting for all Tri-Clamp model Fermenators.

Repalcment Racking Arm Fitting for all Tri-Clamp Fermenator models.